From: F. Brian Mead (brian@hardscrabblefarm.com)
Date: Thu May 29 2003 - 17:22:11 PDT
found this article on the web a while back & ordered a can of it. I got
the Acetone version, not the MEK version. You just have to paint in on the
spots where the enamel has come off...if you paint good enamel, the stuff
will peel. I've done 6-7 cans so far with good results.
The stuff is normally used for lining new water tanks for boats, but works
great for the water cans too.
Brian Mead
WATER TANK REPAIR: Jan/Feb 2000, Vol 5, No 1 Passagemaker Magazine p. 114
Ed Babniuk
Repair of metal water tanks which leak on the inside and are too difficult
to remove. Use Microseal, an FDA approved non-toxic and odorless, thin
liquid plastic type material. Available from Microseal company of Rome, New
York. Phone 315-337-2720 at $36/gal. You must first open the access ports
on your water tank and clean it out (pressure sprayer), then let it
completely dry (shop wet vac to suck up as much as possible). Remove the
water connection fittings so they don't get gunked then plug the hole with
something. Microseal is dissolved in Methyl Ethel Ketone (MEK - nasty
stuff) which evaporates after 3 days to leave the sealant bonding with the
tank. One gallon microseal in the water tank (unknown size). Can use garden
sprayer to get it up high on walls if needed. If not just slosh it around
to cover bottom and corners. Don't use heat gun to dry (explosive).
Question of whether it would also work on metal fuel tanks or deck leaks,
but not tested.
At 01:36 AM 5/27/2003 -0500, you wrote:
>Any suggestions?
>
>Jon
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:20:33 PDT