From: Marc Strangfeld (curlyjoe98@yahoo.com)
Date: Sun Jun 22 2003 - 22:27:45 PDT
Thanks all for your responses. I plan to wire the
lights as "je" did. But the newly acquired M105
trailer and leaking transfer case seals along with new
seat installations in the M35 will push back the
wiring job as it is not usually my favorite task.
Thanks again.
Marc
--- jonathon <jemery@execpc.com> wrote:
>
> >Mark, its working as it should. Jonathon Emery
> posted the following some time
> >ago and its very credible if one wants the parking
> light operational while
> >driving. Enjoy; Kenny
>
> Thanks for the credit. I did the splice of the two
> circuits as I outlined
> and it all works fine. Just take the plug off the
> back of the light switch
> and pull the harness down, find the two wires, cut
> them, strip them back (4
> ends) then stick them into a butt splice
> (uninsulated) two wires on each
> side, crimp, solder (optional I suppose) and then
> slide a piece of double
> wall shrink tube (the type with the melt glue in the
> middle) over it (before
> you crimp and solder !!!!!) and that's about it.
>
> Have not made any progress on the other DOT stuff,
> I'm finding my gama goat
> more interesting at the moment.
>
> later,
>
> je
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to:
> <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:21:46 PDT