From: Greg (czechsix@cox.net)
Date: Tue Jul 01 2003 - 18:24:10 PDT
Bob - Bjorn Brandstedt is on this list - he did an article on converting
over to 11.00x20 singles in a past MV magazine. Try to find a copy, or maybe
he'll photocopy it for you. If you can't get hold of him, I can copy it for
you.
It looks like all you do is flip the hubs around, and put singles on the
rear. Wheels are like on the front axle, convex side out. Flipping the hubs
converts them into the same track width as the front wheels - better for mud
and sand. But less stable. For me, I'm converting over to 11.00x20 duals.
There are quite a few 11.00x20 single tired deuces coming out of the Marine
Corp DRMO's.
Greg
Vista, CA
----- Original Message -----
From: "Robert.Wilson" <specwar@piace.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Tuesday, July 01, 2003 4:07 PM
Subject: [MV] 11.00x20's on a deuce
> I have an M35 I want to change to 11x20's , How do I install the tires on
> the intermediate and rear drive axles in place of the duals? Do I not use
> the lugs and just the buds? Are the rims installed like on the front axle
> or opposite? Also, How much does this add to the height of the deuce? My
> tech data doesn't really give any instructions for installing 11x20's.
>
> Bob
> 1964 American General M35A2C
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:22:44 PDT