Re: [MV] Replacing MULE drop axel needle bearings (follow up!)

From: Steve Grammont (islander@midmaine.com)
Date: Mon Jul 21 2003 - 14:58:08 PDT

• Next message: Employee@MilVeh.com: "Re: [MV] Lack of armor in Iraq - or a lack of sense?"
• Previous message: John Souza: "5 ton M62 Wrecker hydraulic hoses"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Sorry, meant to say:

2. "Chisel Method" - remove the needles and use a fine chisel to crack
the bearing casing in one place and try and gently pry the bearing casing
inwards so that it can be pulled out. Failing that, chisel in two places
so that you have one small and one large piece. Pull out the small piece
and then the larger piece.

Steve

• Next message: Employee@MilVeh.com: "Re: [MV] Lack of armor in Iraq - or a lack of sense?"
• Previous message: John Souza: "5 ton M62 Wrecker hydraulic hoses"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:22:47 PDT