From: Fred Martin (mung@in-touch.net)
Date: Wed Jul 23 2003 - 05:32:28 PDT
Better keep in good with that brother...sounds as if he is confident in
his welding. Take him that ten dollar angle grinder and a rattle
can...tell him to fix it back. Fred Martin
Sando wrote:
> I didn't kill him but rest assured he'll NEVER use it again!!!
> Sando
> ----- Original Message -----
> From: "Sando" <asando@prtc.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Tuesday, July 22, 2003 6:31 PM
> Subject: [MV] pintle hook bracket for M-1009
>
>
>
>>List:
>> My brother used my CUCV for a few days and saw fit to weld a
>
> piece
>
>>of metal to the pintle hook bracket to attach a hitch ball for towing his
>>boat!! Needless to say, now I'm stuck with an ugly contraption on the
>
> rear
>
>>bumper. Before trying to remove it, maybe someone has the bracket
>
> somewhere
>
>>lying around willing to sell it for a few bucks!!!
>> I need just the bracket, everything else is OK. The pintle hook is
>>bolted directly to the bracket and is located on the license plate cut
>>out(duh!) The part is item #35 figure 145, section 11, page 376 ,
>>TM-2320-289-34P.
>>
>> Thanks
>> Sando
>>
>>
>>===Mil-Veh is a member-supported mailing list===
>>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>>To reach a human, contact <ack@mil-veh.org>
>>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:22:48 PDT