From: Glen Bedel (GBedel@designforum.com)
Date: Fri Aug 08 2003 - 05:03:09 PDT
1/4" cold rolled steel is still thicker than a set of utilities out in the
open. I'm sure the guys will appreciate it. And besides it could be kind of
hard aiming at the truck when .50 cal rounds are chewing up the sand around
you.
-----Original Message-----
From: Bobby Joe Pendleton II [mailto:bobbyjoe@chartertn.net]
Sent: Thursday, August 07, 2003 7:27 PM
To: Military Vehicles Mailing List
Subject: Re: [MV] Cold roll
Hot or cold roll is to soft to much with bullets and a will not slow a RPG
down. Armor plate has to be heat treated to be much good
----- Original Message -----
From: "Everette" <194cbteng@pchnet.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Thursday, August 07, 2003 5:13 PM
Subject: Re: [MV] Cold roll
> I have a friend that has salvage yard and he buys Armored trucks, he
cannot
> sell truck body, engine transmission, drive train cab sheet metal,
> etc.
The
> Armour is two sheets of steel with about 3 inches concrete between
> them.
I
> would guess steel to be less than 1/2 inch. I have no idea if is hot
> roll or cold roll.
>
>
> Everette
>
> I WILL LIFT UP MY EYES TO THE HILL,
> FROM WHENCE DOES MY HELP COME,
> MY HELP COMES FROM THE LORD WHO
> MADE HEAVEN AND EARTH.
>
> ----- Original Message -----
> From: "Bruce Beattie" <bruce@eecs.berkeley.edu>
> Subject: Re: [MV] Cold roll
> I wonder what the weight difference between the desert fine sand and
> say beach sand like we have over here is? Bruce MVPA 23824
>
> Bobby Joe Pendleton II wrote:
>
> > you can also double wall it and put sand in between the walls
> >
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org> To reach a human, contact
> <ack@mil-veh.org>
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org> To
reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:23:34 PDT