From: Bobby Joe Pendleton II (bobbyjoe@chartertn.net)
Date: Mon Aug 11 2003 - 16:54:57 PDT
correct , a minimum of 30 psi at 3000 RPM and 10 pounds for every 1000 RPM
above that
----- Original Message -----
From: "David Cole" <DavidCole@tk7.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, August 10, 2003 12:26 PM
Subject: Re: [MV] oil pressure
> For Chevy race engines I have heard that 10psi per 1000 RPM hot is best.
>
> Dave
>
> On Sat, 9 Aug 2003 17:21:02 -0500, Everette <194cbteng@pchnet.com> wrote:
>
> > I remember reading somewhere that if an engine could hold as much as
5psi
> > oil pressure there would not be metal to metal contact.
> >
> > hear ye, hear ye, flame away - not my statement just something I have
> > read
> > somwhere in the last 60 years and did not forget.
> >
> > Everette
> >
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
>
>
> --
> Dave
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:23:35 PDT