CUCV Starter Rebuild

From: Bruce Beattie (bruce@eecs.berkeley.edu)
Date: Thu Aug 14 2003 - 22:39:47 PDT

• Next message: Jeff H: "Re: [MV] Jeeps"
• Previous message: djslager: "Re: [MV] SA-18 GAM"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi All,
    I am rebuilding my starter, and the TM states to put some grease on
the end shafts
and to lubricate the spiral portion of the shaft, but that is all.

Can any one tell me if I am supposed to lubricate the colar that the
solenoid lever
rides in, and with what. The solenoid lever is that yoke shaped thing
with the two
steel nobs that slide in the colar to push it into the flex plate.

Any other tips on this assembly would be appreciated. So far this looks
good, but I don't want to screw it up.

Thanks,
Bruce MVPA 23824

• Next message: Jeff H: "Re: [MV] Jeeps"
• Previous message: djslager: "Re: [MV] SA-18 GAM"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:23:36 PDT