From: noel shelley (noel@shelley1722.freeserve.co.uk)
Date: Wed Sep 17 2003 - 15:56:47 PDT
Ryan,
Using the unthreaded part of a long HT bolt as the pin it is a
simple task to make your own . A stout piece of bar machined , filed or
ground to the right diameter and cross drilled , then heated and bent or cut
in three and welded to shape . If a large diameter is needed then thick
walled tube suitablly bent with stub formed as above and welded in does the
job
Good Luck Noel
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:24:26 PDT