From: Fred Martin (mung@in-touch.net)
Date: Mon Oct 06 2003 - 07:02:29 PDT
Also most sparkplug threads are of the metric configuration...so if you
have an old American lathe you might run into a wall here. Most just cut
SAE type threads. Usually the sparkplugs are 10, 14 and 18 (old)
millimeters in diameter...FYI Fred Martin
noel shelley wrote:
> DO NOT be tempted to try and use ether injection and a thermostart [flame
> heater ] at the same time , it maywell go BANG !
>
> Noel
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:25:00 PDT