From: m35products (m35prod@optonline.net)
Date: Tue Oct 28 2003 - 13:40:33 PST
All the water and fuel pumps on M35-series trucks use a PTO mounted on the
Transfer case. That way you can regulate the speed of the output, dependent
upon the tranmission gear.
apb
----- Original Message -----
From: "John Brian Seeling" <JBSeeling@cox-internet.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Tuesday, October 28, 2003 4:00 PM
Subject: [MV] M35A2 PTO questions.
> Got a deuce with the Spicer 3053A transmission and the Spicer WN-7-28 PTO
> (winch kit PTO).
> Want to build a couple of water trucks, and the water pump requires at
least
> 1800 rpm at the pump.
> #1: Will the WND-7-28 PTO (just like the winch PTO, but has both front
and
> rear output shafts) spin up to 1800 rpm at the rear shaft? (the
rear-output
> is not in the same place as the front output, so I am a little concerned
> that it won't spin as fast)
> #2: If not, is there a rear-output PTO that will do the trick?
> #3: Anybody know a good source for Spicer or comparable parts for the
> WND-7-28 PTO's? I will probably need at least one complete PTO with the
> rear shaft and other rebuild parts as I go along.
>
> Thanks,
> - John Brian Seeling
> Twin Bridges Company
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:25:03 PDT