From: Bjorn Brandstedt (super_deuce@hotmail.com)
Date: Fri Oct 31 2003 - 16:24:32 PST
Yes, on our1952 M43 there is provision for a hand crank on the engine
damper/pulley, a slip release kind of thing plus the hole in the bumper and
relief in the radiator. The 1952 M37 only has the bumper and radiator
mods./Bjorn
>From: Joe Foley <redmenaced@yahoo.com>
>To: Bjorn Brandstedt <super_deuce@hotmail.com>
>Subject: Re: [MV] Hand cranking the M37
>Date: Fri, 31 Oct 2003 14:29:19 -0800 (PST)
>
>Is the front of the crankshaft made for one?
>
>I doubt they'd issue one, they are a safety hazard.
>
>Even when properly used!
>
>Joe
>
>
>
>
>--- Bjorn Brandstedt <super_deuce@hotmail.com> wrote:
> > Does anyone know if a crank for hand cranking
> > (starting) the early M37 type
> > trucks was ever issued?/Bjorn
> >
> >
>_________________________________________________________________
> > Concerned that messages may bounce because your
> > Hotmail account has exceeded
> > its 2MB storage limit? Get Hotmail Extra Storage!
> >
> > http://join.msn.com/?PAGE=features/es
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to:
> > <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
> > <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
>
>__________________________________
>Do you Yahoo!?
>Exclusive Video Premiere - Britney Spears
>http://launch.yahoo.com/promos/britneyspears/
_________________________________________________________________
Never get a busy signal because you are always connected with high-speed
Internet access. Click here to comparison-shop providers.
https://broadband.msn.com
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:25:04 PDT