Re: [MV] rusty doors M35

From: R. A. Moir aka RAM (cyclopsram@starband.net)
Date: Thu Nov 06 2003 - 05:09:45 PST


There was a mwo regarding drilling 1/2 inch holes in the bottom of the doors
to let the water out... If the door is set too close to the rocker
panel...the water won-t drain.. RAM
----- Original Message -----
From: "James M. Atkinson" <jmatk@tscm.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Wednesday, November 05, 2003 22:49
Subject: Re: [MV] rusty doors M35

>
> Nope,
>
> Sandblast FIRST (scale as needed), then use a rust inhibitor ASAP...
> THEN apply two coats of Rustoleum.
>
> -jma
>
>
> At 9:21 PM -0800 11/5/03, patrick jankowiak wrote:
> >I notice I have some small holes in the door bottoms of ye olde M35.
> >Rust sometimes shows up on the rocker panel from these. Any ideas? a
> >liberal spraying indside with rustoleum? Don't care about the holes,
> >just want to stop the rust.
> >
> >===Mil-Veh is a member-supported mailing list===
> >To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> >To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> >To reach a human, contact <ack@mil-veh.org>
>
>
> --
>
> --------------------------------------------------------------------------
------------------------
> The First, The Largest, The Most Popular, and The Most Complete TSCM,
> Bug Sweep, Spy Hunting, and Counterintelligence Site on the Internet.
> --------------------------------------------------------------------------
------------------------
> James M. Atkinson Ph: (978) 546-3803
> Granite Island Group Fax: (978) 546-9467
> 127 Eastern Avenue #291 http://www.tscm.com/
> Gloucester, MA 01931-8008 mailto:jmatk@tscm.com
> --------------------------------------------------------------------------
------------------------
> "Those who advocate beating their swords into plowshares generally
> wind up plowing for those who didn't." - Benjamin Franklin.
> --------------------------------------------------------------------------
------------------------
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>



This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:26:25 PDT