From: Glenn Shaw (wolf.star@verizon.net)
Date: Wed Dec 03 2003 - 07:44:03 PST
-----Original Message-----
From: Glenn Shaw [mailto:wolf.star@verizon.net]
Sent: Wednesday, December 03, 2003 10:44 AM
To: 'TacticalTruck@aol.com'
Subject: RE: [MV] HMMWV glow plugs in CUCV?
Yes you can but the non swelling plugs are very expensive. Around
150.00 for set of 8. Other than that it's a good idea. I have been
considering the same thing on a M1009. Much cheaper is to pick up a set
of 12v AC60G non swelling temp compensated plugs and keep the resistor.
50.00 for set of 8 on ebay all the time.
Glenn
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org] On
Behalf Of TacticalTruck@aol.com
Sent: Wednesday, December 03, 2003 9:15 AM
To: Military Vehicles Mailing List
Subject: [MV] HMMWV glow plugs in CUCV?
Any one ever try Humvee glow plugs in a CUCV? I thought I could by-pass
the
balast resistor and use non-swelling HMMWV plugs. Opinions?
Jeff
TacticalTruck.com
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:26:55 PDT