From: Bobby Joe Pendleton (bjpendleton@charter.net)
Date: Wed Dec 10 2003 - 17:12:30 PST
I use 90PSI and a 1 inch drive on my M211
----- Original Message -----
From: "Stephen & Jeanne Keith" <cckw@comcast.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Wednesday, 10 December, 2003 20:04
Subject: Re: [MV] Changing tires on m35's
> >From my experience, you need a 175 psi compressor and a good
> 3/4 inch impact wrench
>
> I do not believe the M35 compressor will do. I believe that is why t
> they had the 24 volt electrics
>
>
> Steve AKA Dr Deuce
>
>
> ----- Original Message -----
> From: "Willie McClain" <wiandci@comcast.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Wednesday, December 10, 2003 7:21 PM
> Subject: [MV] Changing tires on m35's
>
>
> > Hi, I am collecting up things I will need for my m35 and was wondering
if
> a
> > impact wrench I seen in a harbor freight book would work to change the
> tires
> > using the compressor that's on the truck. It's a 1/2" with a maximum
> torque
> > of 625 ft lbs. Uses 4.7 SCFM of air. Also would a 12 ton bottle jack be
> good
> > enough to jack it up ? What kind of jack did they come with ? Thanks
> Willie
> >
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:26:56 PDT