From: Bruce Beattie (bruce@eecs.berkeley.edu)
Date: Fri Dec 12 2003 - 22:20:43 PST
I thought the injection pump had to bet adjusted differently.
Bruce MVPA23824
"Neil E. Amrhein" wrote:
> So, in other words, the water pump should be the *only* piece needed?
>
> ----- Original Message -----
> From: "Julian Burke" <julian@knology.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Friday, December 12, 2003 3:50 PM
> Subject: Re: [MV] HMMWV 6.2 to 6.5 swap & parts interchangability?
>
> >
> > NO! Everything outside the engine will fit but heads will NOT. Water is
> > circulated different in the engine and water pump is different also. Julian
> >
> >
> > List,
> > In swapping a 6.5 into a formerly 6.2 powered HMMWV, are there any
> > engine parts that are not interchangeable? In other words, if I wanted to
> > put a reman 6.5 long block into a 6.2 powered HMMWV, would all of the other
> > parts fit properly (manifold, injectors, injector lines, injector pump,
> > water pump, exhaust manifolds, etc...)? I think the answer is yes, but I
> > want to know for sure.
> >
> > Thanks,
> > Neil
> >
> > =Mil-Veh is a member-supported mailing list=
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:26:57 PDT