From: Bruce Beattie (bruce@eecs.berkeley.edu)
Date: Sun Dec 21 2003 - 07:25:28 PST
I would stick with the 2A bassed on the fact that the guy pulled a 2A fuse out
of the pump.
Bruce
Ron wrote:
> FWIW...
>
> From:
>
> TM 9-2320-209-20-3-1
>
> Make sure that fuel pump replacement fuse is 2 amperes. Higher ampere fuse
> could cause fuel to explode if pump overheats.
>
> HOWEVER,according to:
>
> TM 9-2320-361-20
>
> Page
>
> 3-33
>
> 1. Install 4-ampere fuse (7) on terminal cover (1).
>
> So it's a Hobsons choice on the CORRECT rating, eh?
>
> Ron(zo)
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:26:58 PDT