From: Ron (rojoha@comcast.net)
Date: Sun Jan 18 2004 - 13:16:10 PST
1) http://www.owens-export.com/humvee.html
2) http://www.thetoolwarehouse.net/shop/OTC-6005.html
and the aforementioned Snap-On tool.
But the best tool was an deep socket on an air ratchet spinning like
crazy while you applied a lot of leverage on a GM door trim removal tool
which fits like it was made to go around the barrel of the glow plug after
it was unscrewed from the block enough to clear the threads.
Does the above make sense to those of you who have done this goat rope
before?
----- Original Message -----
From: "Julian Burke" <julian@knology.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: 17 January, 2004 18:59
Subject: [MV] Tool Needed
> I need help from the list. Someone a while back had the special sockets
for
> R & R'ing the injectors for the 6.2 & 6.5 diesels. I need to find one and
> need the help in locating one. Thanks all, Julian
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:02 PDT