From: Stu (stuinnh@comcast.net)
Date: Mon Jan 26 2004 - 15:06:00 PST
Steering Bell crank?
"Stu"
Southern New Hampshire, USA
"Live Free Or Die"
*Wanted to Buy: MP Red Light for my Mutt windshield*
Military Vehicle Preservation Assoc.
Merrimack Valley Military Vehicle Collectors
Green Mountain Military Vehicle Club
Vehicles:
1967 M151A1 Jeep
1964 M416 1/4 Ton Trailer
1986 M1009 CUCV Blazer
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org] On Behalf
Of Thomas M McHugh
Sent: Monday, January 26, 2004 5:01 PM
To: Military Vehicles Mailing List
Subject: [MV] M38A1 Steering Gear ???
I recently replaced Steering Bellcrank Shaft. That tightened up the front
end some & eliminated quite of a bit of play. After completion, it not has
shown play & noise in the Steering gear box.
Question: There is visible play in the Steering Gear Shaft & Bearings on
my M38A1. Other than the replacing the Shaft, Bearings & Gasket, should
anything else be replaced while doing the job ???
I prefer doing a thorough job once.
As always, I appreciate all replies from the list.
Tom McHugh, NJ
1952 M38A1
M-416 Trailer
MVPA, MTA
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:03 PDT