From: James Shanks (n1vbn@bit-net.com)
Date: Sat Feb 07 2004 - 19:09:36 PST
Why not just use a steering wheel puller? They are generally universal in
what they fit and it allows you to pre load the steering wheel..if it
doesn't move after you pre load it THEN wack it in the center of the hub
with the nut flush with the threads. Had to use one on a 72 Chevy PU the
other day..one wack to the center and off she popped.
James Shanks
n1vbn@arrl.net
1998 IMZ 8.103
1984 HD FLHT-C
At 04:44 AM 2/7/2004, noel shelley wrote:
>Hi ,
> The following may help ! I do not know your vehicle but general
>principles are as :-
>Loosen the nut on the steering column leaving the nut flush with the top of
>the shaft , pour BOILING water over the boss then with a block of wood
>against the under side of the boss hit with a hammer . alternatively try to
>pull /push off then strike the nut hard .
>If this doesn`t work then try a gear puller , you may have to make an
>adaptor to fit under the wheel .
>
> Good luck Noel
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:32 PDT