From: David Cole (DavidCole@tk7.net)
Date: Wed Feb 11 2004 - 12:01:50 PST
I don't know the alloy, but I replaced a brass pin that was sheared off
when I got the truck, and installed a home made pin from some soft aluminum
I got from a home store. So far so good.
Dave
M51
M200A Trailer
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> .
On Tue, 10 Feb 2004 13:52:40 -0800, J <W7LS@blarg.net> wrote:
> Are these just simple aluminum rods with clips on each end? Any special
> alloy or just use plain old 6061-T6 from the store? Thanks. Jim
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
-- Dave
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:33 PDT