From: MV Don Low (MVdonlow@hotmail.com)
Date: Thu Feb 26 2004 - 17:42:22 PST
Thanks Stu, My problem however is its not supposed to recline at all.
Its a not reclining seat, at least it used NOT to be, now the metal is
giving way ;-(
And the left side has rusted metal and is missing a finger wide section,
hence no support for the back nor the bottom.
Its like being sucked down, a black hole . slowly
I am not sure a reclining seat would be a bad idea tho, might like that on
long days at the shows ;-)
----- Original Message -----
From: "Stu" <stuinnh@comcast.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Thursday, February 26, 2004 7:01 PM
Subject: Re: [MV] M1009 drivers seat, NEEDED
> Or, you can use the reclining seat back hinges from GM. It's nice to be
> able to adjust seat back.
>
> "Stu"
> Southern New Hampshire, USA
> "Live Free Or Die"
>
> Military Vehicle Preservation Assoc.
> Merrimack Valley Military Vehicle Collectors
> Green Mountain Military Vehicle Club
> Vehicles:
> 1967 M151A1 Jeep
> 1964 M416 1/4 Ton Trailer
> 1986 M1009 CUCV Blazer
>
>
> -----Original Message-----
> From: Stu [mailto:stuinnh@comcast.net]
> Sent: Thursday, February 26, 2004 7:54 PM
> To: 'MV Don Low'; 'Military Vehicles Mailing List'
> Subject: RE: [MV] M1009 drivers seat, NEEDED
>
> Hi Don!
> The seat hinges are still available from GM. You can order from your
local
> Chevy dealer. Also, seats are same as civy unit. Also check junk yards.
>
> "Stu"
> Southern New Hampshire, USA
> "Live Free Or Die"
>
> Military Vehicle Preservation Assoc.
> Merrimack Valley Military Vehicle Collectors
> Green Mountain Military Vehicle Club
> Vehicles:
> 1967 M151A1 Jeep
> 1964 M416 1/4 Ton Trailer
> 1986 M1009 CUCV Blazer
>
> -----Original Message-----
> From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org] On
Behalf
> Of MV Don Low
> Sent: Thursday, February 26, 2004 7:35 PM
> To: Military Vehicles Mailing List
> Subject: [MV] M1009 drivers seat, NEEDED
>
> I am in need of a Drivers Seat for my 1984 M1009 (Chevey Blazer, full
size )
> The seat frame is broken, !
> The back is GOING Backward and the seat is going down, its really hard to
> drive it that way ;-(
> The rack that the seat sits on is fine (bolts to the truck and seat,
> (adjusts back and forth ) is ok)
> Seems they are harder to find than I thought !
>
> Any Ideas where I can get one? Or a set ??
>
>
> Don Low
> donlow.50g.com
> www.MKMVPA.com
>
> Understanding requires not just a moment of perception, but a continuous
> awareness, a continuous state of inquiry without conclusion. (Bruce Lee)
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:37 PDT