From: Baker, George R. - Eastman (grbaker@eastman.com)
Date: Sun Mar 28 2004 - 18:25:02 PST
It is more than likely a top for the new 5 tons, same length but taller. If you add to the uprights it makes a nice top with room to almost stand up in.
GRB
-----Original Message-----
From: vislocky [mailto:vislocky@prodigy.net]
Sent: Sun 3/28/2004 8:20 PM
To: Military Vehicles Mailing List
Cc:
Subject: [MV] FW: 2 1/2 Ton Cargo Camo Vinyl Cover
Hello Listers:
I purchased a camo vinyl cargo cover this weekend at the Crestview, Florida
MVPA swap meet. The top is supposed to be for a 2 1/2 ton M35A2 type cargo
truck. I installed it today and it fits great length wise but hangs down to
the bottom lip of the cargo bed. My previous installed canvas cover was
about 8 inches or so shorter on each side lining up basically just above the
tie downs. This top covers the tie downs all together. Any ideas how these
vinyl cargo covers are supposed to fit?? Also, the end covers are part of
the top and appear identical with no window cut out. Which is the front, or
does it matter? Any help would be greatly appreciated. Thank you, Kevin
MVPA 8173
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:29:14 PDT