From: Recovry4x4@aol.com
Date: Sun May 02 2004 - 11:24:18 PDT
Plaz, no need to get too worried about this one. if you're going to work on
one of these injector pumps, the thing you really need is a 5/8" crowsfoot and
maybe even a 5/8" line crowfoot. You may be able to weave the crowfood in
with an extension but probably not. Pulling the intake is not a big deal.
Probably a 90 minute job off & on. There is a possibility that the line is cracked
too. This happens when the little brackets that hold the lines to the valve
covers aren't attached. Heres what you do! Pull the intake, tighten up the line
and reattach the battery grounds that were pulled to remove the intake. Start
it up & test it before reinstalling the manifold. Once you're happy that the
leak is fixed, reinstall the intake. Lokks worse than it is.
Kenny
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:29:56 PDT