From: Patrick Jankowiak (recycler@swbell.net)
Date: Thu May 06 2004 - 15:25:03 PDT
This explains much.. I have an adapter bushing missing from the kit.
Ray Fougnier wrote:
> Mine go into the front right of the engine. One is just above the
> alternator and the other is almost right above it towards the top of the
> engine. Shutoff valves are in both places so I can isolate the core to
> work on it, or stay cooler in the summer. It's at work, or I would take
> a picture for you.
>
> Ray
>
> Patrick Jankowiak wrote:
>
>> I finished the install of the hot water heater in the M35..
>>
>> I used the connections (pipe plugs) before and after the thermostat. I
>> am not sure this is the right place..
>>
>> any body know where it should go? The directiones were not good,
>> showed a different motor.
>>
>>
>>
>> ===Mil-Veh is a member-supported mailing list===
>> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>> To reach a human, contact <ack@mil-veh.org>
>>
>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:29:56 PDT