Re: [MV] mil manual on winch pins and alloys?

From: noel shelley (noel@shelley1722.freeserve.co.uk)
Date: Fri May 21 2004 - 07:34:30 PDT

• Next message: Ryan Gill: "Re: [MV] CAN ANY BODY HELP ?"
• Previous message: noel shelley: "CAN ANY BODY HELP ?"
• Maybe in reply to: m35products: "Re: [MV] mil manual on winch pins and alloys?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Jim and List ,
                           The formula for shear strength is :-
P = A x S. Where P is the total stress in pounds .
                                    A is the cross sectional area in square
inches
                                     S is the permisssible working stress in
Lb/sq "
NOTE . PWS for shear use 4/5 that of permissible stress in tension .

Wish I was really this clever BUT sadly not -- had to look it up in a book .

                    Hope it helps Noel

• Next message: Ryan Gill: "Re: [MV] CAN ANY BODY HELP ?"
• Previous message: noel shelley: "CAN ANY BODY HELP ?"
• Maybe in reply to: m35products: "Re: [MV] mil manual on winch pins and alloys?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:29:59 PDT