From: Bobby Joe Pendleton (bjpendleton@charter.net)
Date: Thu Jun 03 2004 - 18:50:52 PDT
the last can of WD-40 I bought would not burn.
"Maneo Qualis Manebam"
----- Original Message -----
From: "R F" <rfougnier@comcast.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Thursday, 03 June, 2004 21:24
Subject: Re: [MV] Ignition cables
> Sort of like using carb cleaner to clean the inside of a distributor
cap???
>
> So WD40 will no longer be flammable, or is changing to become
> flammable? I have to go try this....
>
> If you don't hear from me, call 911.
>
> Ray
>
>
> everette wrote:
>
> > I have been told that in the last few months formula for WD40 has been
> >changed so that it will no longer act as starting fluid -- I do not know
> >this from personal experience - just something I picked up somewhere.
And
> >as so ably stated it causes all sorts of problems when used as a "water
> >displacing" agent.
> >
> >
> >Everette
> >
> >----- Original Message -----
> >From: "noel shelley" <noel@shelley1722.freeserve.co.uk>
> >Subject: Re: [MV] Ignition cables
> >
> >
> >Must be brief , Keep all leads VERY clean , as oil draws dampness .
> >use rubber kichen gloves as boots to keep dampness from distributor ,
coil
> >top Etc. WD40 and the like will get a wet engine started ,but then cause
all
> >manner of problems later .
> >KEEP IT CLEAN .
> >
> >best wishes Noel
> >
> >
> >
> >
> >===Mil-Veh is a member-supported mailing list===
> >To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> >To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> >To reach a human, contact <ack@mil-veh.org>
> >
> >
> >
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:33:21 PDT