From: Steve & Jeannie Keith (cckw@comcast.net)
Date: Mon Jun 14 2004 - 15:53:12 PDT
Caster is done with wedges between the front axle and springs.
Camber is done by bending the housing with a special setup
Steve AKA Dr Deuce
----- Original Message -----
From: "Ida Heath" <spike@defuniak.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Monday, June 14, 2004 6:37 PM
Subject: Re: [MV] duece front wheel alignment
> How do you adjust the caster and camber on a deucenahalf?
>
> Sonny
>
>
> ----- Original Message -----
> From: tom-fastest_m-35 <milveh@carr.org>
> To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
> Sent: Monday, June 14, 2004 1:21 PM
> Subject: [MV] duece front wheel alignment
>
>
> > you do all realize that caster, camber and toe are all adjustable if you
> > really want to? that would help if you wanted to drive on paved roads
> > most of the time.
> > tom
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:33:24 PDT