From: m35products (m35prod@optonline.net)
Date: Sat Jun 19 2004 - 08:49:39 PDT
"Kroil" will do it.
apb
----- Original Message -----
From: "Jim Zehr" <jimm1009@yahoo.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Saturday, June 19, 2004 11:24 AM
Subject: [MV] alternative penetrating oil
> NAPA also has a fluid similar to WD40 but they swear
> that it will penetrate into a one millionth of an inch
> area.
> I have used it and it does work very well. Like
> everything else at NAPA it is a little pricey (about
> $5.00 per can).
> Obviously there are times when only the heat wrench
> will work but I would definetly try these products
> first with the use of six point sockets and or
> wrenches. Twelve point tools have their place but
> will often round the corners on old rusted-down
> fasteners.
> Heat and soak and then heat and soak. Switch between
> slightly tightening to slightly loosing the fastener
> and more soaking.
>
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! Mail - 50x more storage than other providers!
> http://promotions.yahoo.com/new_mail
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:33:25 PDT