Re: [MV] Fwd: Lube for Vinyl Cab Top Installation

From: JoeYoungInc@aol.com
Date: Wed Jul 21 2004 - 13:23:25 PDT

Next message: Richard J. Thiers, Jr.: "RE: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Previous message: Ryan Gill: "Fwd: Lube for Vinyl Cab Top Installation"
Next in thread: uniquemachine@cybcon.com: "Re: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Maybe reply: uniquemachine@cybcon.com: "Re: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Maybe reply: Ryan Gill: "Re: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Maybe reply: Mel Miller: "Re: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Soak the channel with silicone spray. After the
top is removed, inspect the channel for places that
were crimped to hold a canvas top. Open the tight
spots up a little. I use a side motion with the
claws of a rip hammer inserted where needed.
Joe Young

Next message: Richard J. Thiers, Jr.: "RE: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Previous message: Ryan Gill: "Fwd: Lube for Vinyl Cab Top Installation"
Next in thread: uniquemachine@cybcon.com: "Re: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Maybe reply: uniquemachine@cybcon.com: "Re: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Maybe reply: Ryan Gill: "Re: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Maybe reply: Mel Miller: "Re: [MV] Fwd: Lube for Vinyl Cab Top Installation"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:33:54 PDT