From: Mike Maynard (mike@wesleyscott.com)
Date: Tue Aug 03 2004 - 19:44:39 PDT
Jim, I am pretty sure, that it is standard dock high, which is 48" I know I
have had mine backed into the dock at work, and its less than an inch
different.
Mike
-----Original Message-----
From: Jim Stead [mailto:gadget@easypath.com]
Sent: Tuesday, August 03, 2004 10:44 PM
To: Military Vehicles Mailing List
Subject: [MV] M35 Bed height
My deuce is parked on uneven ground on a sharp hill, and at 10:45 PM my
suburban yuppie neighbors will not enjoy me moving the deuce to the street
to take measurements....
Anyway, sob story aside, does anyone know the bed height of an M35A2
with 9x20 tires? I think it's about 46" or so? If anyone knows offhand, that
would help a lot....I'm designing some ramps to load a low-clearance
forklift in the bed from a 42" dock. Angles are important! :-)
Thanks,
Jim
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:34:18 PDT