From: Ida Heath (spike@defuniak.com)
Date: Wed Aug 11 2004 - 19:52:38 PDT
how much weight will the eyes inside the M35A2C bed hold roughly? Enough to
safely secure a farm tractor for hauling?
Sonny
----- Original Message -----
From: everette <194cbteng@bellsouth.net>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Sent: Wednesday, August 11, 2004 9:35 PM
Subject: [MV] Hauling IN an M35
> I saw an M35 that owner had welded two plates of steel about foot square
in
> front corners of bed and then to them welded grab hook for chain. At back
> of bed underneath he put two more pieces of steel with keyhole shaped
slot
> in them and in bed. Hooks chain at front as close as he can, drops rear
> chain through hole turns chain such that catches in narrow part of slot,
> puts load binder in rear to tighten and this also tightens front if
hauling
> wheeled vehicle. If hauling cargo puts load binders on both ends. He
said
> would have put hooks at back but was afraid someone would stumble over
them
> and do header out back of truck..
>
>
> Everette
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:34:20 PDT