From: Larry Tighe (larryradio@worldnet.att.net)
Date: Tue Aug 31 2004 - 14:21:07 PDT
Thanks Bruce,
The radial tire sez 40 lbs., max. But, I don't think the MUTT would ride
too well with that much.
Lar
www.antiquetelephone.com
----- Original Message -----
From: "Bruce C. Beattie" <bruce@eecs.berkeley.edu>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Tuesday, August 31, 2004 4:38 PM
Subject: Re: [MV] M151A2 Tire Pressure
> Hi Lar & List,
> Shouldn't that info be on the tire itself?
> Not shure if there is a difference between that and the actual
> application preasure.
> Bruce MVPA 23824
>
> Larry Tighe wrote:
>
>> Just replaced the NDT's with radials.
>>
>> The NDT's required 22 lbs pressure. Can I assume the radials would be
>> the
>> same pressure? Or, is there so much difference in tires that that's not
>> a
>> good assumption? Anyone know what is the correct pressure if not 22 lbs.
>>
>> Many thanks,
>>
>> Lar
>>
>> www.antiquetelephone.com
>>
>> ===Mil-Veh is a member-supported mailing list===
>> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>> To reach a human, contact <ack@mil-veh.org>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:34:23 PDT