From: Jim Stead (gadget@easypath.com)
Date: Fri Sep 03 2004 - 06:14:53 PDT
The gasket maker I was thinking of last night is Permatex "The Right Stuff".
Jim
> Which seal? Inner, Outer, keyway?
> Take a look at http://208.190.133.201/axle/m35_axle_seals.html
>
> A lot of people use form-a-gaskets for various applications. I've never
used
> that stuff for a wheel seal, but I can say it has worked 100% the first
> time, every time, everywhere else I've used it. Blue, Orange,
Copper...maybe
> I've just been lucky. Still, if no one here says this is a bad idea, I'd
> give it a try myself.
>
> Wasn't there a thread here lately praising a particular modern product?
Or,
> did I see that somewhere else? Something, I think, in a cheeze-wiz like
can?
>
> CRS syndrome, sorry.
>
> Jim
>
>
>
>
>
>
> ----- Original Message -----
> From: "sandman9" <sandman9@optonline.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Thursday, September 02, 2004 9:01 PM
> Subject: [MV]
>
>
> > Looking for NAPA # for wheel seals on a M35A2
> > John Peterson
> > MTA
> > CJMMP
> > MVPA
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:35:11 PDT