From: m35products (m35prod@optonline.net)
Date: Fri Sep 03 2004 - 14:56:03 PDT
Maybe a few discretely-located one-inch circles of black or dark green
velcro, permanently applied to the roof, and mating pieces, with the wire
sandwiched between, will work. I used that scheme on a detective's car that
required the occasional use of a rotating light on the roof. The permanent
dots are practically invisible at 50/50. (50 feet/50 mph)
apb
----- Original Message -----
From: "Darrell Ramsell" <daram@comcast.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Friday, September 03, 2004 4:22 PM
Subject: [MV] Need good tape
> Gents
>
> I have a 24v solerizer on top of my HMMWV. Duct tape was originally used
> to cover the exposed wire on top but it doesn't hold up very long in the
hot
> sun plus is a pain to remove the glue after I take it off. I've tried
> electrical tape and it seems to be an improvement but I still need
something
> better.
>
> So my question is does anybody know of a tape that tolerate high heat and
> not permanently bond itself to the body?
>
> Thanks
>
> Darrell
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:35:11 PDT