From: Jim Stead (gadget@easypath.com)
Date: Wed Sep 29 2004 - 05:31:38 PDT
Make sure your running the engine at the correct RPM. That'll affect it
a LOT.
After that, there are tests and adjustments you can make on the voltage
regulator, assuming it's not bad, but you'll need the correct TM for that
unit. I don't have that TM, sorry.
Jim
> OK Gang, who's the resident expert on these gensets. I have 2 of them.
Today
> I got both running but not at the same time. I only have one good magneto.
> Anyway, neither set develops correct voltage. Voltage at the convenience
plugs
> was around 60 to 70. The machines are set at 120/240 single phase. The
voltage
> across L2 and L3 shoud be 240 and its like 170. I've tried the field flash
and
> checked the fuses but nothing seems to work. Anybody have any suggestions
on
> these sets?
> Thanks,
> Kenny
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:35:16 PDT