From: Bruce C. Beattie (bruce@eecs.berkeley.edu)
Date: Thu Sep 30 2004 - 09:44:47 PDT
Hi Ronzo,
I once got a kit from JCWhitney to relocate the spin on oil filter for my
F250.
I am wondering if you couldn't use this to adapt.
Just a thought.
Bruce
Ron wrote:
> This thread intrigued me. My filter cans also leak, sometimes a little,
> sometimes a lot, with no consistency. While I can find lots of pictures
> showing the canisters on 2150's, not much about the "kit".
> However, go here to read a little about the oil that leaks up from the
> 'discs' pressed into the Herc oil filter manifold.
> The service bulletin photo is a little hard to make out, but appears to
> involve drilling the block....
>
> http://olivergang.org/discus/messages/619/732.html
>
> Ronzo
>
> ----- Original Message -----
> From: "Marc Strangfeld" <curlyjoe98@yahoo.com>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: 27 September, 2004 13:15
> Subject: [MV] spin on oil filter adapter update
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:35:16 PDT