M35A2 Tranny Input shaft seal

From: frey2@eng.usf.edu
Date: Wed Oct 06 2004 - 13:16:11 PDT

• Next message: Recovry4x4@aol.com: "Front Drive Axle Parts Wanted"
• Previous message: Larry Tighe: "Fw: [MV] FW: [MV] Air over hydraulic brake information for possible M35a2 swap?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Ok i managed to some how soak my clutch in gear oil, it appears that the
oil is coming from the input shaft of the tranny. It is the spicer 3053a
behind the LDT 465. I have the input shaft cover off and the input shaft
removed. How does it keep oil in the tranny case. There is a plate on
the case side of the bearing which seems like if it sealed oil out it
would run the bearing dry. I have the tranny manual but it does not
explain why things are or how they work. Does anybody know how this all
works?

Thanks,

Nicholas Frey
Competition Support
Society of Automotive Engineers
University of South Florida
frey2@eng.usf.edu

• Next message: Recovry4x4@aol.com: "Front Drive Axle Parts Wanted"
• Previous message: Larry Tighe: "Fw: [MV] FW: [MV] Air over hydraulic brake information for possible M35a2 swap?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:49 PDT