Re: [MV] M35A2 Tranny Input shaft seal

From: Jeff J Alberhasky (jalberhasky@juno.com)
Date: Wed Oct 06 2004 - 15:02:51 PDT

• Next message: noel shelley: "Re: [MV] FW: [MV] Air over hydraulic brake information for possible M35a2 swap?"
• Previous message: Bill Kealey: "Re: [MV] Fuel Question"
• Next in thread: Sonny Heath: "Re: [MV] M35A2 Tranny Input shaft seal"
• Maybe reply: Sonny Heath: "Re: [MV] M35A2 Tranny Input shaft seal"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

There is no seal for the input shaft. The tranny must be over filled or
the rear main on the engine is leaking bad. Jeff

• Next message: noel shelley: "Re: [MV] FW: [MV] Air over hydraulic brake information for possible M35a2 swap?"
• Previous message: Bill Kealey: "Re: [MV] Fuel Question"
• Next in thread: Sonny Heath: "Re: [MV] M35A2 Tranny Input shaft seal"
• Maybe reply: Sonny Heath: "Re: [MV] M35A2 Tranny Input shaft seal"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:49 PDT