From: Roger (rog@miniequine.com)
Date: Wed Oct 06 2004 - 17:27:22 PDT
Sonny and group,
Another question about a deuce tranny: Mine slings some oil from the rear
seal/shaft - it's mostly a pain because it gets up into the floor cover
plate seams, etc. The bearing seems fine, has zero play so I assume its
just the rear tranny seal that's shot. I have the oil level up to the fill
plug (nothing leaks out the front). Now if it happens to be the rear tranny
seal, can I change it without dropping the tranny? If so, what should I
order other than the seal itself? Tips appreciated, I'm a new guy on the MV
block. BTW, just changed my transfer case on my own, so I guess I've been
indoctrinated by fire!
Roger
M35A2
VN Vet 66,67
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org]On
Behalf Of Sonny Heath
Sent: Wednesday, October 06, 2004 7:54 PM
To: Military Vehicles Mailing List
Subject: Re: [MV] M35A2 Tranny Input shaft seal
Nick,
If its like mine it has no front seal and oil is NOT supposed to get out the
front unless the gearbox is overfull. It should be at least an inch BELOW
plug level when cold but I keep mine about two inches. The input shaft
cover has a rifle in it right? Thats what keeps the oil from coming out
unless you had it overfull.
Sonny
----- Original Message -----
From: <frey2@eng.usf.edu>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Sent: Wednesday, October 06, 2004 3:16 PM
Subject: [MV] M35A2 Tranny Input shaft seal
> Ok i managed to some how soak my clutch in gear oil, it appears that the
> oil is coming from the input shaft of the tranny. It is the spicer 3053a
> behind the LDT 465. I have the input shaft cover off and the input shaft
> removed. How does it keep oil in the tranny case. There is a plate on
> the case side of the bearing which seems like if it sealed oil out it
> would run the bearing dry. I have the tranny manual but it does not
> explain why things are or how they work. Does anybody know how this all
> works?
>
> Thanks,
>
>
> Nicholas Frey
> Competition Support
> Society of Automotive Engineers
> University of South Florida
> frey2@eng.usf.edu
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:49 PDT