Re: [MV] where to connect heater hoses?

From: The Nallins (enallin@earthlink.net)
Date: Wed Oct 13 2004 - 23:31:54 PDT


Hey Sonny,

What's a mere 1000 lbs. among friends? Besides, I've looked high and low,
inside and out, and I still can't find that extra half truck many of you
guys have. Is that from the lineage of the half track?

Sorry

Gene

----- Original Message -----
From: "Sonny Heath" <sonny@defuniak.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>; "The Nallins"
<enallin@earthlink.net>
Sent: Wednesday, October 13, 2004 7:44 PM
Subject: Re: [MV] where to connect heater hoses?

> You may find the info you need if you look in deuce and a half books
instead
> of deuce books. lol
>
> Sonny
>
>
> ----- Original Message -----
> From: The Nallins <enallin@earthlink.net>
> To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
> Sent: Wednesday, October 13, 2004 1:31 AM
> Subject: [MV] where to connect heater hoses?
>
>
> > Hi all, I haven't posted in a while. Did have the deuce in a local
parade,
> > carrying the Methodist kids' bell choir- not sure if that was more of a
> > treat for them or me!
> >
> > Winter is coming, and I have acquired a hot water heater kit (to heat
the
> > cab) for the deuce- 1970 turbo multifuel. Problem is, only very sketchy
> > instructions came with the kit. I cannot find much info on my CD with
> deuce
> > manuals.
> >
> > So can anyone 1) direct me to the right section of the CD or 2) scan and
> > email directions or 3) just tell me where to connect the hoses at the
> > engine?
> >
> > A diagram with the kit shows one hose coming off near the stat, the
second
> > from the LEFT side of the engine. The only diagram I found on the CD
shows
> > both hoses coming from the right front of the engine.
> >
> > I'm guessing the return hose connects to the water pump, just above the
> > alternator. Does the other hose come off just to the engine side of the
> stat
> > housing? If so there are three pipe plugs here, does it make any
> difference
> > which? Finally, any tips for removing VERY rusty plugs?
> >
> > Thanks again to all the contributors, and God bless! Gene
> >
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
>



This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:50 PDT