From: Buzz (buzz@softcom.net)
Date: Thu Oct 14 2004 - 09:54:29 PDT
Rick,
I haven't replaced the rubber, but if it's hardened and cracked I remove it, then grit blast the
shield and finally wire brush it with a fine wire brush.
If the rubber is just dirty and nasty looking grit blasting will make it look like new than add a
coat of armor all.
Buzz
On Thu, 14 Oct 2004 08:21:02 -0700 (PDT), you wrote:
>
>Has anyone replaced the rubber covering on shielded
>spark plug leads?
>
>Thanks,
>Rick
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:50 PDT