Re: [MV] Wanted to buy:

From: Stephen L Dussetschleger (dussetschleger@juno.com)
Date: Mon Nov 08 2004 - 16:02:39 PST

• Next message: Jim Newton: "Re: [MV] M35A2 Clutch Alinement Tool Dimensions?"
• Previous message: Jim Newton: "M35A2 Clutch Alinement Tool Dimensions?"
• Next in thread: m35products: "Re: [MV] Wanted to buy:"
• Reply: m35products: "Re: [MV] Wanted to buy:"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

 Are these the assemblies tha tkinda look like a chain clamp that wrap
around the square tube axle housing of the duece & 1/2's ?
Steve

• Next message: Jim Newton: "Re: [MV] M35A2 Clutch Alinement Tool Dimensions?"
• Previous message: Jim Newton: "M35A2 Clutch Alinement Tool Dimensions?"
• Next in thread: m35products: "Re: [MV] Wanted to buy:"
• Reply: m35products: "Re: [MV] Wanted to buy:"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:37:39 PDT