From: flyn3nvt@adelphia.net
Date: Fri Nov 12 2004 - 03:29:20 PST
Been a while since I have seen how that set up is........but if its like any rubber product, its tight and a pain............when I did my draft pads on my M37 for the clutch and brake pedals, i used CRC's Electromotive Cleaner. Spray it on the rubber and it will make it swell and become very pliable for like 2 min.........so once it starts to evaporate, it goes back tight again.........did my draft pads in under 5 min. A little aviation trick I learned over the yrs.
Jeffinvt
>
> From: "Bruce C. Beattie" <bruce@eecs.berkeley.edu>
> Date: 2004/11/11 Thu PM 10:51:06 EST
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Subject: [MV] PTO boots on M54A2
>
> Hi all,
> Does anyone know of a way to extract a boot off of a PTO without
> damaging it.
> ie so I can put it on another PTO.
> Thanks,
> Bruce MVPA 23824
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:37:40 PDT