From: m35products (m35prod@optonline.net)
Date: Mon Nov 22 2004 - 20:56:59 PST
NO NO NO NO NO NO
What if you have forgotten to leave it in neutral.
What if (a dozen other possibilties).
apb
----- Original Message -----
From: "Joe Garrett" <j.garrett@verizon.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Monday, November 22, 2004 5:51 PM
Subject: Re: [MV] Word to the wise...
> Everybody please add a remote starter switch to your tool box if you are
> going to do this kind of thing. It is a momentary switch with two wires
> ending in small alligator clips. You clip the alligator clips to the
posts
> on the starter and then, when you are 3 or 4 feet away, you press the
switch
> button. If you have connected to the wrong posts, instead of starting a
> fire, you simply ruin your $10 remote starter switch. And an added
benefit
> is that you don't hit you head on the hood trying to get away from the
> sparks. And you don't ruin your 24 volt starter by arc welding the
posts.
>
> Joe Garrett
>
>
> -----Original Message-----
> From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org]On
> Behalf Of Jack
> Sent: Monday, November 22, 2004 2:42 PM
> To: Military Vehicles Mailing List
> Subject: [MV] Word to the wise...
>
>
> It's not a military vehicle incident, but it does
> apply to diesel engines in general and its a good
> lesson in caution!
>
> I had been working with this dielsel tractor trying to
> get the starter switch working. I needed to use it
> ASAP, so I did what most folks would do, I just hot
> wired it. On a tractor and as most of you know on
> MV's too, this is a real simple process. Takes about
> 5 seconds using a heavy wire or steel tool. In this
> case I touched a screw driver across two contact
> points on the solenoid and she started right up, no
> problem. So far so good.
>
> So I am explaining this process to one of the guys who
> would be driving this tractor. I was showing him which
> places to touch if the tractor needed starting before
> we could get the new switch installed. Still no
> problem and I did it again...perfect.
>
>
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:37:43 PDT