From: Joe Foley (redmenaced@yahoo.com)
Date: Wed Dec 15 2004 - 15:27:55 PST
If you're doing this from the top you will find it
well worth the time and aggravation to rig a sheet of
plywood or a plank to lay on while under the hood
instead of trying to lean over the fender! Especially
if you aren't really tall or have to get to the back
cylinders for long periods. Make it so it sets on the
radiator mount, you can lay your tools on it, too.
Two step ladders and a plank acrossed for one end.
Joe
--- Caleb Pal - MilVeh <m1009@defcon-3.net> wrote:
> Hey all,
>
> Well today was a bit of hell on earth. Tried many a
> different tool, and
> finally resorted to pulling the injector, breaking
> the plug, and gently
> pushing it in until I could grab and pull it out
> with needle nose pliers. So
> far 3 have gone fine that way on the drivers side.
> Need to pull out the
> tranny shift linkage to get the last one on that
> side, and get some Forcepts
> from the doctor, skinny pliers that the neds are
> angled on, and they lock.
> Set of Ac60G's arrive tomarrow. What a PITA. Il'l
> have another update
> tomarrow night, thanks all for the help!
>
> Caleb
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to:
> <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
__________________________________
Do you Yahoo!?
Yahoo! Mail - Helps protect you from nasty viruses.
http://promotions.yahoo.com/new_mail
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:38:53 PDT