From: Darrell Ramsell (daram@comcast.net)
Date: Sun Feb 06 2005 - 13:25:34 PST
Eric
I have a similar problem in where my oil gage was reading too high. It
turned out that the wiring between the sending unit and gage was bad.
Darrell
----- Original Message -----
From: "Eric K Davis" <ekd@dolio.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, February 06, 2005 12:09 PM
Subject: [MV] M35A2 Oil Pressure Gauge Question
> My oil pressure gauge isn't working correctly. One question is when the
> ignition switch is turned on does the gauge stay at zero or shoot to the
> max position. My goes to the max position and stays there (so does the
> fuel level gauge). I believe the oil pressure sending unit is good, and I
> know there is oil pressure. I have checked for shorts and 24VDC at the
> gauge and all checks out. Has anyone had experience with these gauges to
> offer hints at what may be wrong or where to look??
>
> Thanks,
> Eric
> M35A2
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:39:50 PDT