From: Bobby Joe Pendleton (bjpendleton@charter.net)
Date: Sun Feb 06 2005 - 13:46:08 PST
Mine would do that after I engaged the pto without pulling the lock pin from
the spool. I sheared the spool lock and had to remove the winch and pull the
end off. to get the broke parts out.
BjP
Southern by the grace of God
"I...Shall Remain Confederate"
----- Original Message -----
From: "Eric K Davis" <ekd@dolio.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, 06 February, 2005 15:12
Subject: [MV] M35A2 Winch Question
> The winch on my M35A2 doesn't free wheel in order to unspool the cable.
> It goes about 1/4 to 1/2 a turn and hits a stop. I verified the winch is
> disengaged from the PTO. Anyone have ideas why it doesn't freewheel
> properly??
>
> Thanks,
> Eric
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:39:50 PDT