From: ALEJANDRO CHAVEZ (achavezv_gm@yahoo.com.mx)
Date: Mon Feb 14 2005 - 05:33:37 PST
Hi list
I was tired of the intermitent failures of my Glow
pulg and the PCB and after I burn the second one
I open one and make some internal conections and the
humvee starts! off course I lost the "protection" of
the PCB and I have to be carefull of not to conect the
bateries in inverted position.., no smoke untill now
and the generator was not charching so I conect other
cable on the line that has current with the fuel
solenoid inside the PCB
so it is possible! and I leave the original conections
in the wiring harness if the next owner want to have
the PCB and GPC at original conditions
will validate this for a while, yesterday it doesn´t
start I think my batery is a bite low for not
recharging it
and still have troubles with starting since I change
the fuel line, I need to purge the lines again
will post a picture of the diagram when I know what I
did... and had no smoke for some time
does somebody remember the time for the glow plugs
when cold, let say -2° C
8 seconds? 12?
Alejandro
_________________________________________________________
Do You Yahoo!?
La mejor conexión a internet y 25MB extra a tu correo por $100 al mes. http://net.yahoo.com.mx
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:39:52 PDT