From: Mil-Veh Co. (milveh@sbcglobal.net)
Date: Wed Feb 23 2005 - 18:55:18 PST
Well, I got er' fixed. Must have been a stuck needle
valve. Blew out all the lines and reassembled, used a
liberal amount of permatex blue silicone sealant on
the base gasket this time. Fired right up, runs fine.
Case closed. Hopefully it will stay this way now at
least until the Tower's event! lol
Thanks again everybody!
--- JoeYoungInc@aol.com wrote:
> Jack,
> Almost all of the vacuum leaks I've found were the
> fault of leaking gaskets.
> Joe
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to:
> <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:39:53 PDT